CAN termination
2 posts
• Page 1 of 1
CAN termination
by jalava » Thu Feb 01, 2018 4:46 am
Does Carberry do CAN bus termination and if it does, can it be turned on or off from software?
- jalava
- Posts: 1
- Joined: Thu Feb 01, 2018 3:43 am
Re: CAN termination
by PAOLOPED » Wed Oct 10, 2018 5:10 pm
Hi,
No is not terminated and cannot be done from software, you need to put a 120 ohm resistor between CAN H and CAN L
thanks and best regards
No is not terminated and cannot be done from software, you need to put a 120 ohm resistor between CAN H and CAN L
thanks and best regards
- PAOLOPED
- Posts: 132
- Joined: Thu Mar 10, 2016 10:34 am
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 0 guests