Carberry Forum

Carberry Development Forum
It is currently Fri Jul 10, 2020 4:17 am

All times are UTC + 2 hours




Post new topic Reply to topic  [ 1 post ] 
Author Message
 Post subject: need help for a project
PostPosted: Thu May 28, 2020 9:00 am 
Offline

Joined: Thu May 28, 2020 8:40 am
Posts: 1
Hi,
i hope, someone can help.

I've a 2007 Acura TL. The Car has a F-CAN high/low and a B-CAN single wire.
I've also installed a 2019 Honda Connect Radio/Navigation System.

I bought the carberry module and have installed them on my Pi2 B with the carberry os.

What i want.
First, i need to communicate with the CAN-Bus of the car.
So i can use one CAN Interface for the F-CAN, because F-CAN is on both car and radio 500kbit/s, but i have to translate the messages between both. Acura has standard frames and the new Honda extended frames.
The B-CAN from the car i can connect to the GMLAN, the B-CAN high/low from the radio on the second CAN Interface of carberry. Here i've to translage the CAN messages and the different speed.

The steering wheel buttons and the hfl buttons i can connect to the 2 LADDER Interfaces. I hope, i can use them with the new radio.

Is that all possible with one carberry and is it very difficult to create all what i need?

regards
Hans


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC + 2 hours


Who is online

Users browsing this forum: Bing [Bot] and 0 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group