https://www.carberry.it/wiki/ 2026-05-13T01:00:25+02:00 https://www.carberry.it/wiki/ https://www.carberry.it/wiki/lib/tpl/bootstrap3/images/favicon.ico text/html 2019-09-30T13:44:54+02:00 https://www.carberry.it/wiki/carberry/cmds/subsys/ignition/events?rev=1569843894&do=diff IGNITION EVENTS This command, can be used to setup notifications of ignition status changes. Synopsis IGNITION EVENTS [<argument>] Arguments Argument Meaning<none> Used to get actual notification status. Returns ON or OFF tokens followed by OK line. text/html 2019-09-30T13:44:54+02:00 https://www.carberry.it/wiki/carberry/cmds/subsys/ignition/ignition?rev=1569843894&do=diff IGNITION Subsystem With Ignition subsystem, you can get informations about the the status of the ignition in the car and manage the behavior of Carberry due to ignition status changes. Also, you can manage the behavior of the ingnition output wire. Please, read Hardware specifications section for more information about electrical wirings. text/html 2019-09-30T13:44:54+02:00 https://www.carberry.it/wiki/carberry/cmds/subsys/ignition/keepalive?rev=1569843894&do=diff IGNITION KEEPALIVE This command, prevent the lowpower state, when ignition is off aborting shutdown procedure during second stage shutdown. Continue to assert IGNITION KEEPALIVE to Carberry, if you need (from Linux domain) to terminate some works. Synopsis text/html 2019-09-30T13:44:54+02:00 https://www.carberry.it/wiki/carberry/cmds/subsys/ignition/notify?rev=1569843894&do=diff EVNT IGNITION ON EVNT IGNITION OFF Evento per spegnimento... EVNT GOTOSLEEP 30 EVNT GOTOSLEEP 29 EVNT GOTOSLEEP .. EVNT GOTOSLEEP 0 Shutdown text/html 2019-09-30T13:44:54+02:00 https://www.carberry.it/wiki/carberry/cmds/subsys/ignition/shutdown_procedure?rev=1569843894&do=diff Shutdown Procedure The shutdown procedure is made of two stages: First Stage The first stage, is triggered when the ignition signal (CAN bus or wired) goes away. During this stage (TIMER1 value) if ignition signal turn on again, TIMER1 value is restored for the next event, and shutdown procedure is aborted. text/html 2019-09-30T13:44:54+02:00 https://www.carberry.it/wiki/carberry/cmds/subsys/ignition/status?rev=1569843894&do=diff IGNITION STATUS This command, reads the status of the ignition line as a logic “OR” of CAN bus ignition flag and wired ignition signal present on pin 3 of Carberry main connector. Synopsis IGNITION STATUS Return The command returns one of the following responses: text/html 2019-09-30T13:44:54+02:00 https://www.carberry.it/wiki/carberry/cmds/subsys/ignition/timers?rev=1569843894&do=diff IGNITION TIMERS This command, can be used to read or setup shutdown timers. Synopsis IGNITION TIMERS [<TIMER1> <TIMER2>] Arguments Argument Meaning<none> Used to get actual timers values. Returns TIMER1 and TIMER2 values (in seconds units) followed by OK line.